Setting The Clock; Nuisance Prevention® Circuitry - Avital 3300L Owner's Manual

To enter or exit Valet Mode using the remote:
Steps 2 through 3 must be quickly and smoothly completed.
1. Open any vehicle door.
2. Press
3. Press
4. Press
The status LED will light solidly if you are entering Valet Mode,
and it will go out if you are exiting Valet Mode.
➜

setting the clock

To set the clock press and hold
ceiver will chirp twice and the hour selection will start flashing.
Immediately press
reverse the hour selection. Once the correct hour is displayed
press again and the minute selection will start flashing. Then
press
minute selection. Once the correct time is displayed simply stop
pressing any buttons for 15 seconds and the transceiver will auto-
matically exit the clock mode.
➜
nuisance prevention
Your system has Directed's Nuisance Prevention
(NPC ). It prevents annoying repetitive trigger sequences due to
®
faulty door pin switches or environmental conditions such as
thunder, jackhammers, airport noise, etc.
24
.
.
again.
to advance the hour selection or
to advance the minute selection or
® circuitry
for five seconds, the trans-
© 2008 directed electronics—all rights reser ved
to
to reverse the
Circuitry
®