Huawei WA635SN-GN Quick Start Manual page 7

Installing the AP
Ceiling mount the AP:
1. Fix a clip holder at the rear side of the AP with two M3*6 screws. The wall-mounting bracket is fixed at the ceiling, and the
AP is hung on the bracket. The clip holder prevents the AP from dropping.
2. Remove the ceiling, determine locations of mounting holes based on the distance between two installation holes, use the
hammer drill to drill holes, and fix the wall-mounting bracket to the ceiling.
35mm
3. Align the cucurbit holes at the rear side of the AP with the four hooks on the bracket. Ensure that the AP is installed in the
correct direction; otherwise, the clip holder cannot fix the AP.
NOTE
The screws provided for ceiling-mounting of APs are 30 mm long and can be used to fix an AP on a ceiling not thicker than
15 mm. To install APs on thicker ceilings, customers need to purchase longer screws.
CAUTION
Ensure that the AP is correctly installed on the wall-mounting bracket and there must be 20 cm space above and around
the AP for maintenance.
NOTE
To prevent unauthorized personnel from moving the AP, lock the AP. The preceding
figure shows the security lock. The carrier should purchase the security lock and
determine the position for installing the security lock.
Lock hole
Ceiling
M4*30 screw
Ceiling
6
Adjustable
buckle
Adjustable
buckle
Wall-mounting
bracket
AP
Security
lock