Table of Contents
Advertisement
Logging In to the Router
Step 3 Select the serial port used on the PC and click OK, as shown in Figure 1-3.
Figure 1-3
Selecting the connected port
Step 4 Click Restore Defaults, select 9600 bit/s from the Bits per second drop-down list box, and click OK, as shown
in Figure 1-4.
Figure 1-4
Setting communication parameters
Step 5 Press Enter on the subsequent dialog boxes until the command line prompt of the user view, such as
<Enterprise AP>, is displayed.
You can run commands to configure the AP. Enter a question mark (?) whenever you need help.
----End
10
Advertisement
Table of Contents
