Assembly - ProForm PFHK99900 User Manual

Assembly

Assembly requires two people. Set the hiker in a cleared area and remove all packing materials. Do not dis-
pose of the packing materials until assembly is completed. Assembly requires the included allen wrench
and your own phillips screwdriver
Note: The underside of the hiker walking belt is coated with high-performance lubricant. During shipping, a small
amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal con-
dition and does not affect hiker performance. If there is lubricant on top of the walking belt, simply wipe off the lu-
bricant with a soft cloth and a mild, non-abrasive cleaner.
Refer to the drawings below to identify the parts used in assembly.
Internal Star
Washer (32)–4
1. Set the Console (99) and the Handrail (27) on the floor.
Locate the Handrail Wire Harness (30) in the Handrail
(27). While a second person holds the Console (99), con-
nect the 8-pin wire of the Handrail Wire Harness to the
HD2 connector on the back of the Console. Next, connect
the 4-pin wire to the IFIT2 connector, and the 3-pin wire
to the HD1 connector shown.
2. Attach the Console (99) to the Handrail (27) with the four
Small Screws (6). Make sure that the Handrail Wire
Harness (not shown) is not pinched between the
Console and the Handrail.
.
1" Upright Bolt (33)–4
Long Upright Bolt (54)–4
Handrail Star
Washer (26)–4
1
HD2
99
27
2
99
6
6
Handrail Bolt (25)–4
Small Screw (6)–4
HD1
IFIT2
30
6
6
27