Table of Contents
Advertisement
To use Held Solo Mode:
• Press and hold the S
• While holding down the S
release any Channel button.
• You can now release the S
the S
OLO
Held Solo Mode will not be engaged.)
• The Channel that you pressed is now soloed, and the
Solo LED is flashing.
• To solo another Channel, press any Channel button.
• To exit Held Solo Mode, press the S
You can also exit Held Solo Mode by pressing the R
M
buttons.
UTE
Remember that the system can only enter Held Solo Mode from the
normal Mix Mode. If you currently have a Channel temporarily soloed
(the Solo LED is lit solid), you must exit the temporary Solo Mode (by
hitting another Channel button or the S
enter Held Solo Mode.
Note: The status of Solo Mode is not saved with a Preset.
Muting a Channel
While creating a mix, any Channel or combination of Channels can be
muted. Unlike the Solo Mode, the changes you make with the M
button can be saved as part of a Preset.
To mute a Channel:
•
Select the Channel first
•
Press the M
•
The yellow LED in the Channel button lights
To unmute a Channel:
•
Select a muted Channel
Press the M
•
•
The yellow LED in the Channel button will go out
Additional Channels can be muted or unmuted by following the same
procedure—first select the Channel, then press the M
button.
OLO
OLO
OLO
button before releasing the Channel button,
button
UTE
button
UTE
button, press and then
button. (If you release
button again.
OLO
ECALL
button) before you can
OLO
UTE
, G
, or
ROUP
UTE
button.
33
Advertisement
Table of Contents
