Faults – What To Do?; Temperature Differs Greatly From The Set Value; Displays Do Not Illuminate - Thermador T18IF900SP Use & Care Manual

en-us Faults – what to do?
3 Faults – what to do?
Before you call customer service, use this table to check whether you can rectify the fault yourself.
d o ? F a u l t s – w h a t t o
Appliance

Temperature differs greatly from the set value.

Displays do not illuminate.

The mains plug has not been inserted properly.
The fuse has tripped.
The power has failed.
The refrigeration unit is switching on more frequently and for longer.
The appliance was opened frequently.
The ventilation openings are covered up.
Large quantities of fresh food have been put in.
Display indicates E....
Electronics have detected a fault.
Appliance is not cooling, display and lighting are lit.
Showroom mode switched on.
--------
24
Switch off appliance for 5 minutes.
~ "Switching off and disconnecting the appliance" on page 16
If the temperature is too warm, check temperature again after a cou-
ple of hours.
If the temperature is too cold, check temperature again on the follow-
ing day.
Connect the mains plug.
Check the fuses.
Check whether the power is on.
Do not open the appliance unnecessarily.
Remove obstacles.
Switch on Super Freeze in good time.
Call customer service.
~ "Customer service" on page 26
Start the appliance self-test.
~ "Appliance self-test" on page 26
When the program has ended, the appliance switches over to normal
operation.