IBM IntelliStation E Pro 6216 Installation Manual page 45

9. Slide the drive into the drive bay through the front, and then attach the drive to
the drive cage.
10. Place the drive cage back into the computer chassis.
11. If you are installing an IDE device, connect one end of the IDE signal cable
into the back of the drive and the other end of the cable into the IDE connector
on the system board. For the location of the IDE connectors, see "System
board internal cable connectors" on page 24. If you are installing a SCSI
device, connect one end of the SCSI signal cable to the device and the other
end to the SCSI connector on the SCSI adapter.
Note: Make sure to route the signal cable so that it does not block the airflow
to the rear of the drives or over the microprocessor.
12. Connect the power cable to the back of the drive. The connectors are keyed
and can be inserted only one way.
13. If you have other options to install or remove, do so now.
14. Replace the cover. See "Replacing the cover" on page 35 for details.
15. Reconnect the external cables and power cords; then, turn on the attached
devices and the computer.
Installing memory modules
You can increase the amount of memory in your computer by installing memory
modules. Your IntelliStation E Pro computer uses industry-standard, PC2100 266
MHz double density RAM (DDR) dual inline memory modules (DIMMs).
Complete the following steps to install a DIMM.
Attention: When handling static-sensitive devices, take precautions to avoid
damage from static electricity. For details about handling these devices, see
"Handling static-sensitive devices" on page 11.
1. Review the safety precautions listed in "Safety information" on page v.
2. Turn off the computer and all attached devices. Disconnect all external cables
and power cords; then, remove the cover. See "Removing the cover" on
page 25 or for details.
Chapter 2. Installing the hardware
33