Assembly - ProForm 831.294230 User Manual

ASSEMBLY

Assembly requires two persons.
dispose of the packing materials until assembly is completed.
Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a
small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal
condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off
the lubricant with a soft cloth and a mild, non-abrasive cleaner.
Assembly requires the included allen wrenches
rubber mallet
For help identifying the assembly hardware, see the drawings below. If a part is not in the parts bag, first
check to see if it has been pre-assembled. If a part is missing, call toll-free 1-800-999-3756.
1/2" Silver Screw
(48)–1
3/4" Bolt (37)–6
1. Make sure that the power cord is unplugged.
With the help of another person, carefully raise the
Uprights (69) to the vertical position. Insert one of the
Extension Legs (63) into the treadmill as shown. (Note: It
may be helpful to tip the Uprights as you insert the
Extension Leg.) Make sure that the Warning Decal (62)
is in the position shown.
Insert the other Extension Leg (63) in the same way.
Set the treadmill in a cleared area and remove all packing materials. Do not
, wire cutters
1/2" Ground Screw
(75)–1
Washer (38)–6
3 1/2" Bolt (64)–2
and your own phillips screwdriver
, and needlenose pliers
3/4" Tek Screw (58)–8
1
6
.
3/4" Screw (2)–12
Wheel Nut (32)–2
69
,
62
63