Cisco ASR 1004 Overview And Installation page 31

Cisco ASR 1004 Router Overview and Installation
DETAILED STEPS
Step 1 Insert an AC power supply in power supply slot 0 or power supply slot 1 until it is fully seated.
Step 2 Tighten the captive screws.
Step 3
Insert the AC power cable into the power inlet.
Step 4 Plug the power supply cable into the power source.
For additional AC power cable strain relief, secure the cable to the power supply handle by inserting a nylon
Note
cable tie through the hole in the handle and around the cable.
Figure 16: Cisco ASR 1004 Router AC Power Supply, on page 31
Figure 16: Cisco ASR 1004 Router AC Power Supply
1
2
3
Note Shielded cables must be used to connect to the DB-25 alarm connector on both the AC and –48 VDC power
supplies in order to comply with FCC/EN55022/CISPR22 Class A emissions requirements. See the
ASR1000-RP Alarm Monitoring Works" section on page 2-22
Step 5 Turn the power supply switch to the On position.
What to Do Next
This completes the procedure for connecting AC input power.
Connecting --48 VDC Input Power to Cisco ASR 1004 Router
This section describes how to connect the –48 VDC power supply in the Cisco ASR 1004 Router.
Figure 17: Cisco ASR 1004 Router –48 VDC Power Supply , on page 31
Figure 17: Cisco ASR 1004 Router – 48 VDC Power Supply
1
AC power supply Standby
switch
AC power supply LEDs
DB-25 alarm connector
–48 VDC power supply
terminal block and plastic
cover
Cisco ASR 1000 Series Router Hardware Installation Guide
Connecting --48 VDC Input Power to Cisco ASR 1004 Router
shows the Cisco ASR 1004 Router AC power supply.
4
5
6
.
shows the –48 VDC power supply.
5
AC power supply fan
AC power inlet
AC power supply handle
"How Cisco
–48 VDC power supply
ground symbol
31