Technical Information - JVC LT-32DP9BJ Instructions Manual

Technical information

If you accidentally cut the power cord
Attach a new plug following the steps below. If in doubt, contact your local
retailer.
Important
Never connect to the larger terminal marked with an "E", the safety earth

symbol " " or coloured green or green-and-yellow.
The wires in the mains lead on this product are coloured with the following code:

• Blue: Neutral wire (connect to the black terminal, or one marked "N")
• Brown: Live wire (connect to the red terminal, or one marked "L")
Change the fuse in the plug
Open the plug as illustrated on the right.
When replacing the fuse, always use a correctly

rated and approved type and re-fit the fuse cover
when finished.
If in doubt, contact your local retailer.
Auto in "Zoom"
When "Auto" is selected in Zoom, the aspect ratio will turn to the ratio
obtained from the information the TV received.
The aspect ratio will turn to the ratio obtained from WSS (Wide Screen

Identification Signal), video signal, or control signal of the external
devices. Without receiving the aspect information, it will be the setting in
"4:3 Aspect Setting". (P. 28)
Digital channels that cannot be watched on this TV
If a digital channel service uses new formats (such as DVB-H or MPEG4,
etc.), or MHP, it cannot be watched even though the channel name appears.
If the channel is selected, the picture will not appear and audio cannot be heard.
* This TV can receive digital terrestrial broadcasting (DVB-T) in the
following countries. Digital terrestrial broadcasting (DVB-T) reception in
other countries is not guaranteed.
Austria, Denmark, Finland, France, United Kingdom, Germany, Italy,
Netherlands, Spain, Sweden, Switzerland, Czech Republic
To record Digital / Analogue channels to external devices

Connect the external device to EXT-1 or EXT-2.
Select a programme you want to record and video / audio will output as
an analogue signal.
Analogue channel video / audio will output from EXT-1 when analogue
channel or EXT-1 is selected.
To record video and audio from another external devices

Connect the external device to EXT-1 or EXT-2.
Select an external device you want to record and video / audio will output
as an analogue signal.
Note
Set the aspect ratio to "Regular" or "Full". The aspect ratio will not be

displayed correctly during recording or playback.
Fuse
You can not output from EXT-1 if you switch to EXT-1 from digital channel.

1080p (1125p) signal is not supported, because they can not be

converted to composite signal.
Supported music formats for Photo Viewer
Sample rate

32, 44.1, and 48 kHz (MPEG-1 Audio Layer-3)

16, 22.05, and 24 kHz (MPEG-2 Audio Layer-3)

8, 11.025, and 12 kHz (MPEG-2.5 Audio Layer-3)

Resolution

16 bit
Channels

monaural, stereo
Bit rate

32, 40, 48, 56, 64, 80, 96, 112, 128, 160, 192, 224, 256, and 320 kbps
Some files may not be able to playback depending on the combination

between the sample rate and the bit rate.
Monitor out (EXT-, EXT-)
0