Spin Selection Button - Hoover WDWFT4138AH Manual

Before you open the door, please
check water level is below the door
opening to avoid flooding.
l
After you have added or removed items,
close the door
START/PAUSE button (the programme
will start from where it left off).
CANCELLING THE PROGRAMME
l
To cancel the programme, press the
ON/OFF button (for at least 3 seconds).
l
Wait 2 minutes until the safety device
unlocks the door.
The option buttons should be selected
before pressing
button.
If an option is
not compatible
programme then the option indicator
first flashes and then goes off.

SPIN SELECTION button

l
By pressing this button, it is possible to
reduce the maximum speed, and if you
wish, the spin cycle can be cancelled.
spin speed cancelled.
l
If the label does not indicate specific
information, it is possible to use the
maximum spin expected in the program.
To prevent damage to the fabrics, it is
not possible to increase the speed
over the maximum allowed for the
programme.
and press the
the START/PAUSE
selected that is
with the selected
l
To reactivate the spin cycle press the
button until you reach the spin speed you
would like to set.
l
It is possible to modify the spin speed
without pausing the machine.
An over dosing of detergent can cause
excessive foaming. If the appliance
detects the presence of excessive foam,
it may exclude the spinning phase or
extend the duration of the program
and increase water consumption.
The machine is fitted with a special
electronic device, which prevents the
spin cycle should
unbalanced. This reduces the noise
and vibration in the machine and so
prolongs the life of your machine.
TEMPERATURE SELECTION button
l
This button allows you to change the
temperature of the wash cycles.
cold wash.
l
It is not possible to raise the temperature
over the maximum allowed for every
programme, in order to save the fabrics.
DELAY START button
l
This button allows you to pre-programme
the wash cycle to delay the start of the
cycle for up to 24 hours.
l
To delay the start use the following
procedure:
- Set the required programme.
13
the load be