ProForm Hot cross buns User Manual page 6

4. Identify the Left Handlebar (6), which is labeled
with an "L." Attach the Left Handlebar to the
Upright (4) with two M8 x 38mm Button Bolts
(45), two M8 Split Washers (52), and two M8
Nylon Locknuts (38).
Attach the Right Handlebar (5) in the same way.
5. The Console (7) requires three 1.5 V "AA" bat-
teries (not included); alkaline batteries are rec-
ommended. Insert three batteries into the bat-
tery compartment (not shown); make sure that
the batteries are oriented as shown by the
diagram inside of the battery compartment.
Connect the Reed Switch Wire (50) to the con-
sole wire. Feed the excess wire into the Upright
(4). Attach the Console (7) to the Upright with
four M3 x 15mm Screws (35). Be careful to
avoid pinching the Reed Switch Wire.
6. Make sure that all parts are properly tight-
ened before you use the lateral trainer.
4
6
52
38
52
45
5
35
4
6
5
4
7
50
Console
Wire
Make sure that
the Reed Switch
Wire (50) does
not get pinched
or damaged dur-
ing this step.