5. On the scanner that is the First Unit needs to be set as
6. Press
The First Unit checks whether the
E/PGM.
When a First Unit receives the response from the CLONE unit, the data transfer starts.
During data transfer, SND and REC flashes.
7. When the data transfer is completed,
USING THE DISPLAY BACKLIGHT
To turn on the display light for easy viewing at night, press
the light sooner, press
USING THE AUTO BACKLIGHT DISPLAY
You can set the scanner so the auto backlight turns on for about 5 seconds when the scanner receives signals.
If you press a key (except
To turn auto backlight display on or off:
1. Press MENU.
2.
Repeatedly press
3.
or
Repeatedly press
MENU
4.
Press
to exit the menu mode.
CHANGING SEARCH SPEEDS
Note: Hypersearch applies only to the 5 kHz step bands (29–54 MHz, 137–174 MHz, and 216–224.9950 MHz).
The scanner has two search speeds.
Normal Search
90 steps/second
TURNING THE KEYTONE OFF/ON
1. Press MENU.
2. Repeatedly press
or
3. Repeatedly press
or
MENU
4. Press
to exit the menu mode.
CLONE unit is connected to correctly.
done
appears. If the data transfer is not successful, Error appears.
again.
) within 5 seconds, the display remains lighted for more than 15 seconds.
AutoLit,
or
to select
ON
OFF
to select
or
Hypersearch
270 steps/second
bEEP,
to display
then press
OFF
ON,
to select
or
FirSt unit.
.The display lights for 15 seconds. To turn off
.
then press
E/PGM
, then press
.
E/PGM
.
E/PGM
then press
.
E/PGM