Seat Assembly - ProForm PFSY92080 User Manual

35. Attach the closed loop at the end of the Low Cable
(72) to the Support Bracket (27) on the Butterfly
Upright (2) with a 5/16Ó x 1Ó Bolt (48) and a 5/16Ó
Nylon Locknut (68).
Note: On the closed loop, the Cable is attached
on one side, while the other side is flat (see the
inset drawing). Make sure the flat side of the
closed loop is facing the Support Bracket.
36. Important: Follow all three Cables from end to
end and make sure they rest in the grooves of all
Pulleys and that both the Cables and the Pulleys
move smoothly.
Unscrew the cable bolt at the end of the High Cable
(73) from the Weight Tube (77).
Thread the 1/2Ó Plain Nut (40) partway onto the cable
bolt.
Slide a 1 1/2Ó Flat Washer (100) onto the cable bolt.
Tighten the cable bolt into the threaded hole in the
Weight Tube (77). Note: The cable bolt is the pri-
mary means for tightening the three Cables (72,
73, 97). Thread the bolt into the Weight Tube until
all Cables are tight and rest firmly in the grooves
of all Pulleys. See page 23 for further information
on tightening the Cables.
When all Cables (72, 73, 97) are tight, tighten the 1/2Ó
Plain Nut (40) onto the 1 1/2Ó Flat Washer (100) on
top of the Weight Tube (77).
Insert the Weight Pin (39) into one of the holes
between the Weights (26).

Seat Assembly

37. Locate and open the parts bag labeled ÒSeat
Assembly.Ó
Attach one Seat (13) to the brackets on the Butterfly
Seat Frame (11) with four 1/4Ó x 3/4Ó Screws (17).
35
68
36
Cable Bolt
39
37
15
2
72
27
Cable on This Side
Flat Side of Loop
73
40
100
77
26
13
11
17
17
48