Table of Contents
Advertisement
Model
XE526SE
The Part
7.The Idler Wheel Assembly
Procedures：
1. Follow procedures 2, 3, 4, 5 & 6 to take
apart the connecting arm, pedal arm, side
cases, the cross bar and the belt.
2. Use 13mm wrench to loosen M8 x 9T
nut with 5/16" x 23 x 1.5T flat washer
on M8x170mm J-bolt and take the J-bolt
apart. Then use again 13mm wrench to
release M8 x 20 carriage bolt, 5/16" x 20
x 1.5T flat washer and M8 x 7T nut,
which secure the idler wheel assembly,
to take it apart, as shown in figures 1 & 2.
3. To take apart the bearing of the idler
wheel, Use C-clip pliers to release ψ17
C-ring on the axle, and 6203 bearing
can thus be taken apart.
4. Reverse above steps to resume all parts.
Work
Replacing Parts
Rev.
1
2
Advertisement
Table of Contents
