5. Connect the Reed Switch Wire (13) to the wire on
the Console (8).
Next, attach the Console (8) to the Upright (2) with
four #8 x 5/8Ó Screws (22).
Press the Resistance Knob (9) onto the Resistance
Control (10). Be sure that the mark on the Knob is
correctly aligned.
6. Finish attaching the Handlebar (4) to the Upright (2)
with two additional M6 x 25mm Hex Screws (14)
and M6 Split Washers (67). Tighten all four Hex
Head Screws.
7. Attach the Seat Bracket (69) to the Seat Frame (3)
with four M6 x 48mm Button Bolts (70) and four M6
Flat Washers (34).
8. Attach the Seat (16) to the Seat Bracket (69) with
four M6 x 16mm Phillips Screws (24).
5
8
Console
Wire
13
22
6
67
14
7
8
6
9
2
10
22
14
67
4
2
70
70
34
34
3
16
24
24
69
69