Assembly - ProForm PFEL91030 User Manual

ASSEMBLY

Assembly requires two persons. Place all parts of the elliptical crosstrainer in a cleared area and remove the
packing materials. Do not dispose of the packing materials until assembly is completed. In addition to the
included allen wrenches, assembly requires a phillips screwdriver
wrench , and a rubber mallet
Refer to the drawings below to identify the small parts needed for assembly. The number in parentheses below
each drawing is the key number of the part, from the PART LIST on page 22. The number following the key
number is the quantity needed for assembly. Note: Some small parts may have been pre-assembled. If a
part is not found in the parts bag, check to see if it has been pre-assembled.
M8 Nylon
Locknut (46)–4
M4 x 16mm
Screw (66)–12
M6 x 16mm Tapered
Button Screw (107)–8
M8 x 45mm Button
Screw (102)–4
M4 x 52mm Screw (98)–2
1. While another person lifts the front of the Frame (1),
thread a Leveling Foot (72) fully into the underside of
the Frame. Next, attach the Front Stabilizer (3) to the
front of the Frame with two M8 x 54mm Button Screws
(33) and two M8 Split Washers (94).
M8 Split
Washer (94)–10
M4 x 16mm Round
Head Screw (45)–1
M8 x 19mm Shoulder
Screw (22)–2
M8 x 54mm Button
.
M8.5 Small
Washer (53)–2
M4 x 14mm Round
Head Screw (93)–2
M8 x 38mm Button
Screw (70)–2
Screw (33)–4
Union Bolt Set (27)–2
1
5
, an adjustable
M10 Washer
(99)–2
M4 x 12mm Round
Head Screw (18)–2
M8 x 43mm Button
Bolt (50)–4
M10 x 35mm Carriage
Bolt (20)–2
3
1
94
94
33 72