Siemens Gigaset S45 Manual page 6

Gigaset S45 / USA EN / A31008-M1754-R101-1-6Z19 / start_guide_time.fm / 30.3.06
First Steps
Attaching the belt clip
There are notches for attaching the belt
clip on the side of the handset at the same
height as the display.
¤
Press the belt clip onto the back of the
handset so that the lugs on the belt clip
click into the notches.
Opening the battery cover
¤
If fitted, remove the belt clip.
¤
Insert your hand into the headset
socket cavity and pull the battery cover
upwards.
Registering your phone
Before you can use your Gigaset S45 you
must register it to a base station. It can be
registered to a maximum of four base sta-
tions. The actual registration procedure
will depend on the type of base station.
6
Automatic registration Gigaset S45 to
Gigaset S450/S455
Important: The handset must not yet be
registered to any base station.
¤
Place the handset in the base with its
display facing outwards.
Registration takes around 1 minute. Dur-
ing this process,
Regstr.Procedure
in the display and the name of the base
station flashes, for example
the handset has been registered, its
screen displays its internal number, for
example INT 2 for internal number 2. The
handset is assigned the lowest available
internal intercom number (1-6). If all
internal numbers 1-6 have been assigned,
number 6 is overwritten, provided the
handset with the internal number 6 is in
idle status.
Notes:
– Automatic registration is not possible when
the base station on which you wish to
register the handset is being used to make
a call.
– Each key press interrupts the automatic
registration.
– If automatic registration does not work,
you will have to register the handset
manually.
Manual registration Gigaset S45
If the handset does not switch on auto-
matically when the batteries are fitted,
you must first charge the batteries.
You must activate manual registration of
the handset at both the handset and the
base station.
After it has been registered, the handset
returns to idle status. The handset's inter-
nal number is shown in the display, for
example INT 1. If it is not, repeat the proce-
dure.
appears
Base 1. When