Configuring Mda Parameters - Alcatel-Lucent 7450 ESS-7 Installation Manual

Configuring MDA Parameters

MDA information must be must be configured before ports can be configured.
After the IOM is configured, use the following CLI commands to provision the MDA(s). A
maximum of two MDAs can be configured on an IOM.
Step 1
Step 2
Step 3
Step 4
To provision an additional MDA, continue the configuration process with Step 5:
Step 5
Step 6
Step 7
Step 8
Example
The following example displays card slot, card type, MDA slot, and MDA type command usage:
ALA-7>config# card 1
ALA-7>config>card# card-type iom-20g
ALA-7>config>card# mda 1
ALA-7>config>card>mda# mda-type m60-10/100eth-tx
ALA-7>config>card>mda# no shutdown
ALA-7>config>card>mda# exit
ALA-7>config>card# mda 2
ALA-7>config>card>mda# mda-type m10-1gb-sfp
ALA-7>config>card>mda# no shutdown
ALA-7>config>card>mda# exit
7450 ESS-7
Command
mda mda-slot
mda-type mda-type
no shutdown
exit
mda mda-slot
mda-type mda-type
no shutdown
exit
Installing IOMs and MDAs
Example
mda 1
mda-type m60-10/100eth-tx
no shutdown
exit
mda 2
mda-type m10-1gb-sfp
no shutdown
exit
Page 97