Preface - Alcatel-Lucent 7450 ESS-7 Installation Manual

A T
BOUT HIS
This guide provides site preparation recommendations, step-by-step procedures to rack mount the
Alcatel-Lucent 7450 Ethernet Service Switch (ESS)
AC power supply modules (PSMs), AC power entry modules (PEMs), DC PEMs, Switch Fabric/
Control Processor Module (SF/CPM), and Input/Output Modules (IOMs).
Each 7450 ESS-7 is shipped with two factory-installed DC power entry modules (PEMs) or AC
power supply modules (PSMs) and AC power entry modules (PEMs), one fan tray, and one filter
tray. Components, such as SF/CPMs, IOMs, MDAs are packaged and shipped separately.
This guide also includes instructions to remove and install field-replaceable parts. Each 7450 ESS-
7 chassis is shipped with blank panels installed in the component slots. Blank panels are required
in empty slots to ensure cooling, for EMI containment during operation, and to prevent dust
accumulation.
After the hardware installation process is completed, refer to the following documents for details
on the boot process, software configuration, and Command Line Interface (CLI) information to
configure system and network parameters:
•
•
•
•
7450 ESS-7
M
ANUAL
7450 ESS OS Basic System Configuration Guide
This guide describes basic system configurations and operations.
7450 ESS OS System Management Guide
This guide describes system security and access configurations as well as event logging
and accounting logs.
7450 ESS OS Interface Configuration Guide
This guide describes card, Media Dependent Adapter (MDA), and port provisioning.
7450 ESS OS Router Configuration Guide
This guide describes logical IP routing interfaces and associated attributes such as an IP
address, port, link aggregation group (LAG), systems with IP interfaces as well as IP and
MAC-based filtering, VRRP, and Cflowd.
®
Model 7, as well as instructions to install
P
REFACE
Page 11