Cornelius VIPER Service Manual page 54

Viper Low overrun Service Manual
Step
4
5
6
7
8
9
W P R
ATER UMP EPLACEMENT
The water pump is located near the rear, center of the unit. It is mounted on a bracket facing the rear of the unit. To replace
the pump, perform the procedure in Table 50.
Step
1
2
3
4
5
6
7
8
9
CO P V
2 ULSE ALVE
The CO valves, shown in Figure 40, are located near the center of the unit and are mounted on a bracket to the
2
bottom of the chassis. They control the injection of CO
ture for the product. There are one of these solenoids for each barrel in the system. When working in this area,
care should be taken not to damage or mis-align the CO
the procedure in Table 51.
Publication Number: 621360241LOEWSE
Remove the mounting screw from the base of the capacitor.
Replace the capacitor.
Reverse the procedure to install the new capacitor.
Reconnect power to the unit.
Refill the barrel with product. See "Filling a Barrel" on page 25.
When barrel fill is complete, perform a motor calibration. See "Calibrating a
Motor" on page 32.
Figure 39. Rear View of Water Pump
Disconnect power from the unit.
Remove the rear cover and the side panels.
Disconnect the CO supply from the unit.
2
Remove and drain the water supply from the unit.
Disconnect the quick disconnect input and output water lines from the bottom
of the pump.
Disconnect quick disconnect CO
Remove the four (4) screws and locknuts holding the pump to the mounting bracket.
Replace the pump.
Reverse the procedure to install the new pump.
R
EPLACEMENT
Table 49.
Action
Table 50.
Action
input from the bottom of the pump.
2
with the syrup/water combination to provide the final mix-
2
metering orifice. To replace one of these valves, perform
2
- 48 -
Water Pump
© 2016, Cornelius Inc.