Cornelius VIPER Installation Instructions Manual
Hide thumbs
Also See for VIPER:
- Service manual (67 pages) ,
- Manual (32 pages) ,
- Operator's manual (22 pages)
Advertisement
Quick Links
INSTALLATION INSTRUCTIONS
S
I
AFETY
NSTRUCTIONS
!
WARNING:
Before starting installation, read and understand all safety label and warnings on the machine. Also review and
understand all safety instructions in the owners, installation and service manuals.
Failure to comply could result in serious injury, death or damage to the equipment.
Q
S
UALIFIED
ERVICE
!
WARNING:
Only trained and certified electrical, plumbing and refrigeration technicians should service this unit.
All wiring and plumbing must conform to national and local codes. Failure to comply could
result in serious injury, death or equipment damage.
S
P
AFETY
RECAUTIONS
This unit has been specifically designed to provide protection against personal injury. To ensure continued
protection observe the following:
!
WARNING:
Disconnect power to the unit before servicing. Follow all lock out/tag out procedures established by the user. Verify all
power is off to the unit before performing any work.
Failure to comply could result in serious injury, death or damage to the equipment.
!
CAUTION:
Always be sure to keep area around the unit clean and free of clutter.
Failure to keep this area clean may result in injury or equipment damage.
Revision Date: July 22, 2020
© 2020, Cornelius Inc.
VIPER FACEPLATE SPACER INSTALLATION
P
ERSONNEL
www.cornelius.com
Viper Faceplate Spacer Kit Installation
- 1 -
Instructions
Revision: A
Publication Number: 629097945INS
Advertisement
Related Manuals for Cornelius VIPER
Summary of Contents for Cornelius VIPER
- Page 1 Viper Faceplate Spacer Kit Installation Instructions INSTALLATION INSTRUCTIONS VIPER FACEPLATE SPACER INSTALLATION AFETY NSTRUCTIONS WARNING: Before starting installation, read and understand all safety label and warnings on the machine. Also review and understand all safety instructions in the owners, installation and service manuals.
- Page 2 Viper Faceplate Spacer Kit Installation Instructions FACEPLATE SPACER INSTALLATION NOTE: Install Faceplate Spacers to prevent potential barrel damage and align the Faceplate evenly on the barrel’s 4 threaded rods. The Faceplate Spacers are part of a kit or can be acquired individually;...
-
Page 3: Installation Instruction
Viper Faceplate Spacer Kit Installation Instructions NSTALLATION NSTRUCTION Table 3. Installation Procedure Step Action Install four (4) new Faceplate Spacers over the threaded rods. Push the spacers back until they are flush with the foam pack. if the spacers are difficult to push in then the installation of faceplate will ensure they are seated properly. -
Page 4: Sanitizing The System
Viper Faceplate Spacer Kit Installation Instructions ANITIZING THE YSTEM The sanitizing process consists of emptying the barrel, washing the lines and barrel, cleaning the BIB connectors, rinsing and refilling the system. Suggested Sanitizers KAY-5® Sanitizer/Cleaner (100 PPM) Mix one packet of KAY-5® Sanitizer/Cleaner per 2.5 gallons of tap water [70°-100°F (24°-35°C)] according to manufacturer's instructions to ensure 100 PPM of available chlorine. -
Page 5: Flushing The System
Viper Faceplate Spacer Kit Installation Instructions LUSHING THE YSTEM Flush the wash water from the system by performing the procedure in Below Table. CAUTION: Flush the system thoroughly, residual sanitizing solution left in the system may create a health hazard. - Page 6 Viper Faceplate Spacer Kit Installation Instructions Publication Number: 629097945INS - 6 - © 2020, Cornelius Inc.