Table of Contents
Advertisement
HULL
HOOD
È
4
1
É
4
1
HANDLEBAR
3
2
1
3
2
1
SERVICE POINTS
Handlebar assembly installation
1. Install:
• Plastic ties 1
• QSTS cables 2
• Handlebar switch lead 3
• Throttle cable 4
NOTE:
After inserting the QSTS cables, handlebar
switch lead and throttle cable into the grom-
mets, tie the end of grommets with the plastic
ties.
È FX/FX High Output
É FX Cruiser/FX Cruiser High Output
2. Install:
• Upper handlebar holder 1
NOTE:
• Align the punch marks a on the handlebar
with the top surface of the handlebar holder.
• The upper handlebar holder should be
installed with the punch mark b facing for-
ward.
CAUTION:
Clearance c should be narrower than
clearance d.
Handlebar holder bolt:
20 N • m (2.0 kgf • m, 14 ft • lb)
LOCTITE 242
Reference clearance:
c: 1.5 mm (0.06 in)
d: 3.5 mm (0.14 in)
79
E
Advertisement
Table of Contents
