ProForm 900L 831.288230 User Manual page 8

HOW TO ADJUST THE REED SWITCH
10
40
8
53
40
If the console does not display correct feedback, the
reed switch should be adjusted. In order to adjust the
reed switch, the Left Side Shield (10) must be
removed. Using an adjustable wrench, turn the Left
Pedal (8) clockwise and remove it from the Crank
(53). Remove the three M4 x 12mm Screws (40) and
the two M4 x 16mm Screws (7) from the Left Side
Shield. Make sure that the arm of the Crank is in the
position shown in the drawing above. Carefully slide
the Left Side Shield forward off the arm of the Crank
and remove it.
53
Next, locate the Reed Switch (49). Turn the Crank
(53) until the Magnet (4) is aligned with the Reed
Switch. Loosen but do not remove the M4 x 16mm
Screw (7). Slide the Reed Switch slightly closer to or
away from the Magnet. Retighten the Screw. Turn the
Crank for a moment. Repeat until the console displays
correct feedback. When the Reed Switch is correctly
adjusted, reattach the left side shield and pedal.
HOW TO ADJUST THE RESISTANCE STRAP
If there is not enough pedaling resistance when the
resistance knob is turned to the highest setting, the
Resistance Strap (15) may need to be adjusted. To
adjust the Resistance Strap, the left side shield must
7
4
7
49
first be removed. Refer to the instructions on page 7
and remove the left side shield.
Next, turn the
resistance knob to
the lowest setting.
Locate and open
the Strap Clamp
(38). Grip the end
of the Resistance
Strap (15) and
pull it up slightly.
While holding the
end of the
Resistance Strap,
fully close the Strap Clamp. Turn the Crank (53) for a
moment to make sure that there is not too much resis-
tance. When the Resistance Strap is properly adjust-
ed, reattach the left side shield and pedal.
HOW TO ADJUST THE DRIVE BELT
The exercise
cycle features a
precision drive
belt that must be
kept properly
adjusted. If the
belt causes
excessive noise
or slips as you
pedal, the belt
should be
checked. To do
this, the side shields must first be removed. Refer to
the instructions on page 7 and remove the left side
shield. Next, remove the right side shield in the same
way.
Press down on
the center of the
Drive Belt (14)
between the
front and rear
pulleys. There
should be from
1/4Ó to 1/2Ó of
movement in
the center of
the Belt. If the
Drive Belt (14) is
properly adjusted, reattach the side shields and ped-
als. If the Belt needs to be adjusted, loosen the Nylon
Locknut (54) on the left side of the Flywheel (29). To
tighten the Belt, turn the Adjustment Nut (30) clock-
wise; to loosen the Belt, turn the Adjustment Nut
counterclockwise. Make sure that the Flywheel is
straight and tighten the Nylon Locknut (54). Reattach the
side shields and pedals.
8
38
53
15
14
Top View
14
30
Top View
54
29