Ordering Data - Siemens 1LA8 Operating Instructions Manual

Spare parts
10.1

Ordering data

In addition to the exact part designation, please specify the machine type and serial number
in all orders for spare parts. Ensure that the spare part designation matches that on the spare
parts list and make sure you use the appropriate part number as well.
Example
● Bearing shield, drive end (Part 5.00)
● Machine type
● Serial number
The machine type and serial number can be found on the rating plate. The serial number is
also stamped on the end face of the shaft extension at the drive end.
Note
The graphical representations in this chapter show schematic diagrams of the basic versions.
They are used for spare parts definitions. The supplied version may differ in details from these
representations.
Risk of explosion
If you use parts other than the original spare parts, the type of protection can no longer be
guaranteed. This can result in an explosion during operation in a potentially explosive
gaseous atmosphere. This can result in death, serious injury or material damage.
● Use only original spare parts for explosion-proof machines; this also applies to
● Commercially available equivalent standard parts such as screws may be used.
Rolling-contact bearings
When ordering roller bearings, in addition to the bearing identification code, the supplementary
specifying code is also necessary for the bearing version. Both of these codes are stamped
on the lubricant plate and specified in the motor documentation, or can also be taken from the
installed bearings.
If roller-contact bearings with an insulated design are installed, use roller bearings of the same
type as spare parts. This will prevent any bearing damage being caused by bearing currents.
SIMOTICS TN Series N-compact 1LA8
Operating Instructions 05/2014
WARNING
components such as seals, terminals, cables and cable entries. Should you have any
questions, please contact the Service Center (Page 143).
10
125