Install The V Ring - Siemens 1LA8 Operating Instructions Manual

3. Prepare the bearing journals:
4. Warm the roller bearing.
5. Push the inner ring of the warmed roller bearing onto the shaft. Avoid any blows that might
6. Make sure that the roller bearing is resting against the shaft shoulder or the second bearing.
7. Fill the bearing to the top with the specified lubricating grease.
8. Warm the grease slinger and push it onto the shaft.
9. Locate the locking ring in the shaft groove or attach the bearing using the shaft nut.
10.Support the rotor for the installation of bearing housing or end shield.
11.Grease the bearing locations (bearing shield/bearing cartridge) with solid lubricant such as
12.Use a suitable sealant when assembling.
13.Install the bearing shield or bearing housing together with the bearing shield.
14.Installed the outer bearing cover if one is being used.
15.Install the sealing elements:
9.2.8.5

Install the V ring

Requirement
The roller bearing is already fitted. The V ring can now be installed for the bearing seal.
SIMOTICS TN Series N-compact 1LA8
Operating Instructions 05/2014
– Lightly oil the inner ring seat.
– Grease the outer ring seat with solid lubricant such as the anti-fretting paste Altemp Q
NP 50.
damage the bearing.
Otherwise, axial vibrations may occur.
the anti-fretting paste Altemp Q NP 50.
V ring (Page 121)
Labyrinth sealing ring (special design) (Page 123)
Maintenance
9.2 Corrective Maintenance
121