COPYRIGHT - All information contained in this manual is the intellectual property of and copyright- ed material of Neets. All rights are reserved. You may not allow any third party access to content, information or data in this manual without Neets’ express written consent.
Page 3
Contact your local Neets reseller or distributor. • If the equipment has slots or holes in the enclosure, these are provided to prevent overheating of sensitive components inside.
Page 5
EcHo Plus can control devices through IR, RS232 or even LAN. EcHo Plus is available in polar white. The drawings in the manual of Neets Control - EcHo Plus is based on the DK, US and EU versions. Function description...
Quick guide to the EcHo Plus Buttons, indicators and connectors are available on the front and rear panels. These are shown below: Front: With front cover Without front cover A/V MUTE PC 1 BLUERAY PC 2 SCREEN Number: Description Push buttons for controlling the AV setup...
Installation The EcHo Plus can be installed in standard electrical back boxes or by using mounting brackets. Each model (DK, US, EU) fits in typical boxes matching specific installation requirements for the country of sale. Prepare the installation site by installing the needed back box or brackets. Pull the needed cables through the back box or bracket.
Page 8
Note that the front cover mounts in only one direction. Paper label Transparent label Front cover Connect and apply power to the control system. Configure the control system using the Neets Project Designer. Page 8 of 13...
Connections and Controls RX-1 Power input port TX-1 Connect the EcHo Plus to the supplied universal TX-2 I/O 3 mains AC power adaptor. Using the supplied 2 pole I/O 2 Neets Control screw block terminal connect white/black wire to EcHo Plus, DK I/O 1 12V and black wire to GND.
GND, as shown above. Use Neets IR-Emitter Use Neets IR-Emitter NEB port The EcHo Plus has a built-in NEB (Neets Ex- tension Bus) which can be used to add 2 NEB devices. Connect your NEB devices as shown to this port with a cable not exceeding 20 cm of length.
LAN port The network connector integrates the system into a local area network. Please connect the EcHo Plus to your LAN if using any of the LAN features of the product. Two LEDs on the connector indicate the following: Color:...
Error indication using LEDs PC 1 If there is a fault in either the configuration or the EcHo Plus unit, this will be indicated on the front button LED indicators. Button LEDs 1-4 are used to indicate the error; the LED indicators are numbered as shown.
2 pin screw block Height, US 105 mm Depth, US 24 mm Product number Weight,EU/DK/US 90 g 310-0152 EcHo Plus EU, white Shipping weight 0,3 kg 310-0252 EcHo Plus DK, white Shipping dimension: EU, DK 310-0452 EcHo Plus US, white...