Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Neets OsCar
Summary of Contents for Neets OsCar
- Page 1 Neets Control – OsCar Installation Manual...
-
Page 2: Foreword
Foreword The purpose of this document is to describe how to install and configure the Neets Control – OsCar DK and EU models. COPYRIGHT - All information contained in this manual is the intellectual property of and copyrighted material of Neets. All rights are reserved. You may not allow any third party access to content, information or data in this manual without Neets’... -
Page 3: Important Safety Instructions
Contact your local Neets reseller or distributor. • If the equipment has slots or holes in the enclosure, these are provided to prevent overheating of sensitive components inside. -
Page 4: Table Of Contents
Quick guide to the OsCar ........ -
Page 5: Description
Description Neets Control – OsCar is a small, but intelligent control system with a minimum of buttons, which makes it very simple to use. With Neets Control – OsCar anyone can start up a presentation without an introduction - just press ONE button and you are ready to begin! Neets Control –... -
Page 6: Quick Guide To The Oscar
Quick guide to the OsCar Buttons, indicators and connectors are available on the front and rear panels. These are shown below: Front: With front cover Without front cover MUTE PC 2 Number: Description Push buttons for controlling the AV setup... -
Page 7: Installation
Installation The OsCar can be installed in standard electrical back boxes or by using mounting brackets. Each model (DK, EU) fits in typical boxes matching specific installation requirements for the country of sale. Prepare the installation site by installing the needed back box or brackets. Pull the needed cables through the back box or bracket. -
Page 8: Eu Version
Note that the front cover mounts in only one direction. Paper label Transparent label Front cover Connect and apply power to the control system. Configure the control system using the Neets Project Designer. Page 8 of 12... -
Page 9: Connections And Controls
TX/IR Neets Control OsCar, DK P/N#: 310-0255 Relay control I/O ports The Neets Control – OsCar has 1 I/O onboard. Relay They can be used for external keyboard, PIR (movement) sensor, keyboard lock, extra relay I/O 1 I/O 2 and so on. -
Page 10: Ir/Rs-232 Port
IR/RS-232 port The OsCar has 1 port (TX/IR) which can be configured (in software) I/O 1 either as RS-232 or as IR emitter. I/O 2 The RS-232 port is used for one- or two-way communication. A +12V two way port is used for devices where reply commands is used. -
Page 11: Troubleshootiong
The USB connector needed to connect to the Neets Control – OsCar is of the type mini USB B 5P . You can either buy this cable from Neets or via the web (buy a USB A to Mini USB B 5P). -
Page 12: Specifications
400 Hz to 500 KHz Default subnet mask 255.255.255.0 Connector 3 pin screw block General Product number Width, EU 55 mm 310-0155 OsCar EU, white Height, EU 55 mm 310-0255 OsCar DK, white Depth, EU 17 mm Width, DK 45 mm Compliancy...