Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Neets Control-UniForm
Summary of Contents for Neets Control-UniForm
- Page 1 Neets Control – UniForm Installation Manual...
-
Page 2: Foreword
COPYRIGHT - All information contained in this manual is the intellectual property of and copyright- ed material of Neets. All rights are reserved. You may not allow any third party access to content, information or data in this manual without Neets’ express written consent. -
Page 3: Important Safety Instructions
Contact your local Neets reseller or distributor. • If the equipment has slots or holes in the enclosure, these are provided to prevent overheating of sensitive components inside. -
Page 4: Table Of Contents
Contents Foreword ............. . 2 Revision list . -
Page 5: Description
Description UniForm is a compact and intelligent AV control system. It is remarkably simple to use, thanks to an intuitive user interface with eight buttons and a crisp E-ink display. With UniForm anyone can start up a presentation without complicated procedures. Simply press ONE button and you are ready to begin! UniForm is a perfect choice for the classroom, meeting or conference room and is easy to install. -
Page 6: Quick Guide To The Uniform
Quick guide to the UniForm Buttons, indicators and connectors are available on the front and rear panels. These are shown below: Front: Number: Description Push buttons for controlling the AV setup with LED status lights Front cover with label for button description Mini USB for programming Rear: Number:... -
Page 7: Installation
Installation The Neets Control - UniForm can be installed in EU, DK(1,5 modul LK FUGA Air) standard electri- cal boxes by using the mounting brackets included in the box. Find the Installation Guide at: https://www.neets.dk/product/neets-control-uniform#Resources Connections and Controls User Interface (E-ink and buttons) -
Page 8: I/O Ports
All of the RS-232/IR ports can be configured in the Neets Project Designer software either as RS-232 or as IR emitter. PIN 5 <-> GND PIN 2 <->... -
Page 9: Lan Port
100Mbit Configuration through USB port Home The USB port is used exclusively for configuring the Uni- My Neets: Form from the Neets Project Designer software. It can’t Username (E-mail) be used to control any external devices. Sign up Login Neets website - sign up The USB port is located on the surface facing the floor when hanging on the wall. - Page 10 Neets extension unit into a PC running Project Designer and follow the instructions. Flashing Flashing Error in serial You need to return the unit to Neets or your local dealer for number replacement/repair. Flashing Resuming factory default When pressing Switch 1 and 4 during power on, the system...
-
Page 11: Specifications
Specifications Network (LAN) Display Speed 10 / 100 Mbit Type E-ink Duplex modes Half or Full Size 2.7 inch DHCP Default off Resolution 264x176 pixels Default IP 192.168.254.252 Colors 1-bit black/white Default gateway 192.168.1.1 Default subnet mask 255.255.255.0 RS-232 / IR port Ports 1 x bidirectional Power over Ethernet...