Debug Mode - P&E Microcomputer Systems TRK-MPC5604P User Manual

6.3

Debug Mode

The SBC MC33905 has a DBG pin to put it into debug mode. Jumpers J4 and
J5 are designed for this purpose.
6.3.1 J4 - SBC DBG Short To GND
1-2 Short SBC DBG Pin to GND, Bypass R21 and D11 (default: OFF)
6.3.2 J5 - SBC DBG Pull Up
1-2 Pull Up SBC DBG Pin to SBC Power Supply via 330 Ohm Resistor
(default: OFF)
6.4 CAN Port
The TRK-MPC5604P board has implemented a CAN port.
TRK-MPC5604P EVB User Manual
Figure 6-4: SBC I/O Signal (J3)
Figure 6-5: SBC DBG Short To GND (J4)
Figure 6-6: SBC DBG Pull Up (J5)
15