Operating Modes - P&E Microcomputer Systems TRK-MPC5604P User Manual

Note: Depending on the operating system, you may see the "Found New Hardware
Wizard" dialog again to assist you with software installation for "PEMicro USB
Serial Port (i1)." Follow the onscreen Windows instructions.
If the TRK-MPC5604P hardware interface driver is now properly installed on
your system, the green USB LED on the TRK-MPC5604P Base Board should
be illuminated. In addition, if you turn on the system power of the TRK-
MPC5604P you will see the yellow Power LED illuminate.
5

OPERATING MODES

5.1 Overview
The TRK-MPC5604P's Embedded OSJTAG circuitry, featured hardware
components, and optional external JTAG header make it a versatile
development tool. Below are some of the featured operating modes of the
TRK-MPC5604P.
5.2 Debug Mode
A host communicates with the TRK-MPC5604P through the Embedded
OSJTAG circuitry. Either the CodeWarrior Development Studio or P&E's
Qorivva software tools will work with the TRK-MPC5604P. Please refer to
Section 8 - TRK-MPC5604P CODE DEVELOPMENT SOFTWARE for more
information.
12
and P&E's USB to Serial circuitry. Depending on the operating sys-
tem, you may see the "Found New Hardware Wizard" dialog to assist
you with installation. Follow the onscreen Windows instructions to
install the OSJTAG driver (these instructions may vary slightly
depending on your specific operating system).
6. Select the "Install the software automatically (Recommended)" option
and click the "Next" button. Windows will install the driver files to your
system. At the end of the installation, click the "Finish" button.
1. Select the "Install the software automatically (Recommended)" option
and click the "Next" button.
2. Windows will install the driver files to your system. Click the "Finish"
button to exit the "Found New Hardware Wizard."
TRK-MPC5604P EVB User Manual