Getting Started With The Trk-Mpc5604P - P&E Microcomputer Systems TRK-MPC5604P User Manual

3

GETTING STARTED WITH THE TRK-MPC5604P

The TRK-MPC5604P is a low-cost board targeting quick microcontroller
evaluation. Please refer to the TRK-MPC5604P Quick Start Guide for
instructions on how to install software, connect the TRK-MPC5604P to your
PC, and run quick demonstrations.
4 SYSTEM SETUP
4.1 Overview
The Embedded OSJTAG driver is required to operate the TRK-MPC5604P
using a PC. The Embedded OSJTAG driver should be installed with the
CodeWarrior Development Studio software before the PC is connected to the
TRK-MPC5604P.
4.2 Operating System Requirements
The following are the resources required to run the CodeWarrior Development
Studio and the TRK-MPC5604P:
10
SBC Reset
J36
Pullup
• A PC-compatible system running Windows 2000, Windows XP,
Windows Vista, or Windows 7
• 128MB of available system RAM, and 1GB of available hard disk
space
• A DVD-ROM drive for software installation
• A USB port
Default Jumper Settings
1-2 (default)
2-3
TRK-MPC5604P EVB User Manual
Pull-Up SBC Reset to 5V if
SBC power is used
Pull-Up to 3.3V if Motor
Control Port is used to
provide power