Silvercrest SBW 60 A1 Operation And Safety Notes page 37

Connect to power
Risk of product damage!
Ensure that the power supply voltage corresponds
to the voltage printed on the back or the underside
of the unit.
Before connecting the AC power cord, ensure you
have completed all other connections.
Connect the mains cable to the AC Socket of the
main unit and then into a mains socket.
Pairing the Wireless Subwoofer with the Main Unit
Automatic pairing
The subwoofer and soundbar will automatically pair when both units are plugged into the mains sockets
and turned on. No cable is needed for connecting the two units.
• When the subwoofer is pairing with the main unit, the Pair Indicator will flash fast.
• When the subwoofer is paired with the main unit, the Pair Indicator will light up.
Note:
• Do not press the Pair button on the rear of the subwoofer, except for manual pairing.
• If the automatic pairing fails, pair the subwoofer with the main unit manually.
Manual pairing
1. Ensure that all the cables are well connected and the main unit is in Standby mode.
Press and hold the Pair button on the rear of the subwoofer for a few seconds. The subwoofer will
2.
enter the pairing mode and the Pair Indicator will blink quickly.
3. Press the button on the main unit or on the remote control to switch the main unit on.
4. After the wireless connection is successful, the Pair Indicator will light up.
5. If the Pair indicator blinks, the wireless connection has failed. Unplug the cable of the subwoofer and
then reconnect the main cable after 3 minutes. Then repeat step 1- 4.
Note:
• If the wireless connection fails again, check if there is conflict or strong interference (for example,
interference from an electronic device) around your location. Remove these conflicts or strong
interferences and repeat the above procedures.
• The subwoofer should be within 6 m of the soundbar in an open area.
• If a TV or an external device is connected to the main unit in AUX mode it and the subwoofer will
switch on automatically when the TV or the external device is switched on.
• If the main unit is not connected with the subwoofer and it is in On mode, the POWER Indicator will
flash. Follow steps 1- 4 above to pair the subwoofer to the main unit.
GB/IE 37