Silvercrest SBW 60 A1 Operation And Safety Notes page 36

Connect to OPTICAL socket
Remove the protective cap of the OPTICAL socket,
then connect an OPTICAL cable (not included) to the
TV's OPTICAL OUT socket and the OPTICAL socket
on the unit.
Note:
While in OPTICAL / HDMI ARC mode, if there's no
sound output and the status Indicator flashes from the
unit, you may need to activate PCM Signal output on
your source device (e.g. TV, DVD or Blu-ray player).
Connect to AUX socket
A: Use the RCA to 3.5mm audio cable
(included) to connect the TV's
audio output sockets to the AUX 1
socket on the unit.
B: Use a 3.5mm to 3.5mm audio
cable (not included) to connect
the TV's or external audio device
headphone socket to the AUX 1
socket on the unit.
Connect to subwoofer
Note:
• For optimal sound, use the supplied Subwoofer
only.
• Connect only speakers with impedance that are the
same or higher than the supplied speakers. Refer to
the Technical data section of this manual.
• Connect the mains cable to the AC Socket of the
subwoofer and then into a mains socket.
36 GB/IE
B A