Disposal of old devices..............7 Operating elements and connections..........8 Installation..................9 System requirements ..............9 Please note before connection!............. 9 Connecting the 2.1 speaker system ..........10 Operation..................11 Troubleshooting ................12 Technical data................. 13 Warranty conditions ............... 14 Silvercrest 2.1-Speaker System SP2010...
2.1 loudspeaker system ... • is not used as intended. • is damaged, incomplete or modified prior to connection and use. The 2.1 loudspeaker system may only be used for private purposes, and not for industrial or commercial purposes. Silvercrest 2.1-Speaker System SP2010...
Compliance with these standards is no longer guaranteed in the event of unauthorised modification or changes to the device. The manufacturer does not accept liability for any damage occurring as a result. Silvercrest 2.1-Speaker System SP2010...
10 cm space on all sides; • The magnets inside the loudspeakers can cause interference on other electrical devices (e.g. mobile phones). For this reason keep the loudspeakers away from other electronic devices. Silvercrest 2.1-Speaker System SP2010...
To prevent a fire hazard if the device is not in use for a prolonged pe- riod (e.g. during holidays), the mains plug should always be discon- nected from the mains socket. Before stormy weather when there is the risk of lightning, disconnect the device from the mains power supply. Silvercrest 2.1-Speaker System SP2010...
Inspect the mains cable from time to time. Do not use adapter plugs or extension cables that do not comply with applicable safety standards, and do not make any alterations to the mains cable or mains plug! Silvercrest 2.1-Speaker System SP2010...
The proper disposal of the old product in this manner will prevent en- vironmental pollution and human health hazards. For further informa- tion about proper disposal contact your local authorities, waste dis- posal office or the shop where you bought the device. Silvercrest 2.1-Speaker System SP2010...
(e.g. computer, MP3 player) : Mains switch (on/off switch) : LED indicator (lights up when the subwoofer is ready for opera- tion) VOLUME: Adjusting the volume TREBLE: Adjusting the high and midrange output BASS: Adjusting the low range output Silvercrest 2.1-Speaker System SP2010...
/ audio device / mains socket must be selected so that the length of the respective cable is suffi- cient. The cables should never be put under strain. • Read the section "Safety Instructions" Silvercrest 2.1-Speaker System SP2010...
(computer, MP3 player). For more information about this, read the audio device documentation. 3. Insert the mains cable plug into an easily accessible mains socket. The 2.1 speaker system is then ready for operation. Silvercrest 2.1-Speaker System SP2010...
3. Adjust the volume of all speakers with the "VOLUME" control knob. 4. Adjust the high and midrange levels with the "TREBLE" control knob and the low range level with the "BASS" control knob. Silvercrest 2.1-Speaker System SP2010...
• The audio output of your audio device is not functional: Refer to the audio device documentation. No audio output on No connection between the satellite loud- satellite loud- speakers and the subwoofer: Check the speakers loudspeaker connection. indicator lights up. Silvercrest 2.1-Speaker System SP2010...
220 - 240 V AC, 50/60 Hz Power consumption during operation 40 W max. in standby Power output (RMS) At 1% total harmonic distortion Subwoofer 12 W Satellites 3 W each Frequency range 80 Hz - 18 KHz Silvercrest 2.1-Speaker System SP2010...