Navien UHA-744SG User Manual page 22

Setting the position of the magnetic sensor
■
( by the magnetic sensors only )
* It sets the position of the magnetic sensor.
* The initial mode is "NO USE".
* In case of NO USE, the alarm function isn't available.
- In the [MANAGER] menu, please select [SENSOR LOCATION] by "+", "-" button.
Then if the user pushes "SET" button, [SENSOR LOCATION] menu would be displayed.
In this case, it shows the currently set status as follows.
- By "+", "-" button, please select the position of installation of the magnetic sensor.
Then the setting is completed by pushing "SET" button.
And then the initial [MANAGER] menu is displayed again.
In this time, according to the set position of the installation, the default value of alarm delay time
is set automatically.
(NO USE : NO USE, WINDOW : 0 MINUTE, DOOR : 1 MINUTE)
- By "+", "-" button, if the user pushes "SET" button at "EXIT", the initial [MANAGER] menu is
displayed again without any change of setting.
※ In case of opened window / door and the wrong sensor connection, the setting of installation
position of sensor selects only "NO USE".
※ In case of the power o during the setting, the changed setting of the installation position is
not recorded.
22