JVC UX-G28 Instructions Manual page 11

To connect the AM loop antenna
Make sure to connect the wire correctly.
1 Hold
2 Insert
For better FM/AM reception
Outdoor FM Outdoor FM
Disconnect the supplied FM antenna,
antenna antenna
and connect to an outdoor FM antenna
(not supplied) (not supplied)
using a 75 Ω wire with coaxial type
connector (IEC or DIN45325).
Vynile-covered wire (not supplied)
Extend it horizontally.
AM loop antenna
Keep it connected.
• Make sure the antenna conductors do not touch any other
terminals, connecting cords and power cord. Also, keep the
antennas away from metallic parts of the System,
connecting cords, and the AC power cord. This could cause
poor reception.
To connect the speaker cords
Make sure the both speakers are connected correctly and
firmly.
3 Release
When connecting the speaker cords, match the polarity of
the speaker terminals: The black cord to (-), the red cord to
(+).
F M
C O A
X L
7 5 Ω
A M
L O O
• If the AM loop antenna wire or speaker cords are covered
P
A M
E X T
with vinyl, remove the vinyl to expose the tip of the
A N T
E N N
antenna wire or speaker cords by twisting the vinyl.
A
1 Unlock
2 Insert
• DO NOT connect more than one speaker to
each terminal.
• DO NOT allow the conductor of the speaker
cords to be in touch with the metallic parts of
the System.
3 Lock
6