Printek FormsPro 4300 Operation Manual page 31

Function
DTR:
XON/XOFF:
ETX/ACK:
Auto CR:
Auto LF:
Long Line:
Left Edge:
FF at TOF:
Scroll Delay:
Possible Values
Power*, Online, or Busy
Off* or On
Off* or On
Off* or On
Off* or On
Wrap* or Trunc
Fixed or Float*
Yes* or No
0, 1*, 2 through 15
Description
Selects the condition to be reflected
by the DTR signal (pin 20 of the
RS-232C interface). Available
only when the RS-232C interface is
installed and Serial is selected.
Enables or disables the
transmission of the XON and
XOFF characters from the printer
to the host to control data flow to
the printer. Not available when
Parallel, or CX/TX is selected.
Enables or disables the ACK
response to receipt of the ETX
character. Not available when
Parallel, or CX/TX is selected.
Enables or disables automatic
Carriage Returns (CR) when a Line
Feed (LF), Vertical Tab (VT), or
Form Feed (FF) is received.
Enables or disables automatic Line
Feeds (LF) when a Carriage Return
(CR) is received.
Sets whether characters beyond the
right margin will be wrapped to the
next line or truncated.
Sets whether the left edge of the
line will be printed 1/2 inch from
the detected edge of the paper or be
fixed at position "0" on the ruler.
Sets whether Form Feeds (FF) will
be performed when received from
the host computer if the paper is
already positioned at the top of
form (TOF).
Sets the number of seconds to delay
before scrolling the top of form to
the tear bar when the printer is idle
and a form boundary has been
reached.
Operation
Page 3-11