Printek FormsPro 4300 Operation Manual page 27

Function
Form #:
F# Path:
F# Auto Cut:
F# CPI:
F# Left Mar:
F# Right Mar:
F# LPI:
F# Length:
F# Top Mar:
F# Btm Mar:
Possible Values
0 through 9
Front, Center, or Rear
Yes or No*
10*, 12, 13.3, 15, 16.74,
17.14, or 20
0* through 134
1 through 255, or MAX*.
6* or 8
1 through 227 (66*)
0* through 255
0* through 255
Description
Allows you to select the desired
form. The printer defaults to the
currently selected form.
Sets the tractor path to be used for
the current form. This function is
available only on the
FormsPro 4503.
Available only when the optional
FormsCutter is installed. See
FormsCutter manual for additional
information.
Sets the character pitch in
Characters Per Inch.
Sets the left margin in columns
(characters) from the leftmost print
position. Column width is based
upon CPI. The left margin must
be less than the right margin.
Sets the right margin in columns
(characters) from the leftmost print
position. A value of MAX sets the
margin to the rightmost print
position, regardless of CPI. The
right margin must be greater than
the left margin.
Sets the line pitch to 6 or 8 lines
per inch.
Sets the form length in lines at the
current line pitch. For example:
for an eleven inch form, enter 66 if
you are using six lines per inch or
88 if you are using eight lines per
inch.
Sets the top margin by adding the
specified number of lines to the
top of the form.
Sets the bottom margin in lines
lines from the bottom of the form.
Operation
Page 3-7