Fim-7910E Hardware Schematic - Fortinet FortiGate-7060E Handbook

FIM-7904E interface module
The 2-C4 interface will no longer be available. Instead the 2-C4/1, 2-C4/2, ..., and 2-C4/10 interfaces will be
l
available.
You can now connect breakout cables to these interfaces and configure traffic between them just like any other
FortiGate interface.

FIM-7910E hardware schematic

The FIM-7910E includes an integrated switch fabric (ISF) that connects the front panel interfaces to the DP2
session-aware load balancers and to the chassis backplanes. The ISF also allows the DP2 processors to
distribute sessions amoung all NP6 processors on the FPM modules in the same chassis.
FIM-7910E hardware schematic
FIM-7920E interface module
The FIM-7920E interface module is a hot swappable module that provides data, management and session
sync/heartbeat interfaces, base backplane switching and fabric backplane session-aware load balancing for a
FortiGate-7000 series chassis. The FIM-7920E includes an integrated switch fabric and DP2 processors to load
balance millions of data sessions over the chassis fabric backplane to FPM processor modules.
The FIM-7920E can be installed in any FortiGate-7000 series chassis in hub/switch slots 1 or 2. The FIM-7920E
provides four Quad Small Form-factor Pluggable 28 (QSFP28) 100GigE interfaces for a FortiGate-7000 chassis.
Using a 100GBASE-SR4 QSFP28 or 40GBASE-SR4 QSFP+ transceiver, each QSFP28 interface can also be split
into four 10GBASE-SR interfaces.
You can also install FIM-7920Es in a second chassis and operate the chassis in HA mode with another set of
processor modules to provide chassis failover protection.
FortiGate-7000
Fortinet Technologies Inc.
FIM-7920E interface module
24