After The Installation - Canon Super G3 Fax Board-AF1 Service Manual

12) Return the following parts to their original position.
- Right Shield Plate
- Link Arm/E-ring
- Developing Assembly Pressure Cover/Lock Lever (Close)
- Right Upper Cover
- Toner Replacement Cover/Right Cover (Close)
- Right Rear Cover 2
- Controller Box (Close)
13) Install the Rear Upper Cover.
MEMO:
Be sure to install the 3 TP screws show in the figure below.

2.2.4 After the Installation

1) Affix the appropriate Modular Label [1] by aligning it with the marking
line on the cover.
MEMO:
Be sure to perform step 2) and 3) for the Europe models only.
2) Install the Modular Cover [1].
- 1 Screw [2] (Use the screws removed in "Installing the FAX Unit" step
4).)
0024-9688
3) Connect the PTT Plug [1] matched the field or area to the PTT Cable (6
contact type) [2].
MEMO:
Do not connect the Telephone Cord (2 contact type) with the PTT Plug.
Chapter 2
F-2-17
F-2-18
2-5