Loop Break Alarm - Omega MICROMEGA CN77000 series User Manual

part
3
O
PERATION

Loop Break Alarm

Display Action
L00P
Press MENU
BR. A L
Press ENTER
L. B . A L
Press ENTER
ENBL
Press MAX
Press ENTER
Loop Break is an additional safety feature intended to monitor the rate of change of the process value, while approaching
Note
the SPI. It is strictly intended as an additional warning system, therefore its use is entirely optional. An active Loop Break
will cause the setpoint digits to blink in a rotating pattern. If the process value reaches the setpoint the blinking will stop
and Loop brA1 is completed successfully, otherwise Loop brA1 will flash and will activate Alr1.
38
: C M
ONFIGURATION
Response
1) Press MENU, if necessary, until the
2) Display advances to
LOOP BREAK ENABLE/DISABLE SUBMENU:
3) Display flashes
4) Scroll through the available selections: Enable (enbl) or Disable (dsbl).
5) Display flashes
ODE
"
Loop Break
"
Loop Break Enable/Disable
" " " "
enbl or dsbl .
" "
strd message and advances to
"
prompt appears.
"
submenu.
" "
Loop Value menu.