Seat Position; Seatback Angle Adjustment - Pride Mobility JAZZY 1103 ULTRA Owner's Manual

V . C O M F O R T
10. Reinstall the retaining clips from step 8.
11. Remove each screw from the trapeze bars and apply thread
lock.
12. Reinstall each screw into the trapeze bars and tighten.
13. Reinstall the seat.
14. Reconnect the controller to the power pod.
15. Reinstall the rear shroud and tighten the fasteners.

Seat Position

You can move the seat forward or rearward by changing the
extrusion mounting position.
To change the position:
1. Turn off the power to the controller.
2. Loosen the rear shroud fasteners and remove the rear
shroud.
3. Unplug the controller connectors from the power pod.
4. Remove the seat from the power base.
5. Remove both extrusions from the bottom of the seat.
6. Reposition the extrusions on a different set of mounting
holes. You must move both extrusions the same number
of holes either forward or backward. See figure 15.
7. Fasten the extrusions back onto the bottom of the seat.
8. Reinstall the seat.
9. Plug the controller connectors into the power pod.
10. Reinstall the rear shroud and tighten the fasteners.

Seatback Angle Adjustment

If your power chair is equipped with an adjustable seatback,
you can adjust it to four (4) different angles: 90°, 102°, 105°, or
107°.
To adjust the seatback angle:
1. Remove the adjusting screws from each seat hinge. See fig-
ure 16.
2. Set the seatback at the desired angle.
3. Reinstall the adjusting screws to each seat hinge and
tighten.
24
A D J U S T M E N T S
Figure 15. Seat Mounting Holes
JAM NUT
SEATBACK
ANGLE
ADJUSTING
SCREW
ARMREST KNOB
Figure 16. Seatback Angle Adjustment
www.pridemobility.com
SEAT MOUNTING HOLES
ARMREST ANGLE ADJUSTING SCREW
Jazzy 1103 Ultra