How To Backup / Restore The System Configuration - Honeywell Touchpoint Plus Technical Handbook

Rectification and Modification

10.5 How to Backup / Restore the System Configuration

You should always take a new back up of the Touchpoint Plus system configuration after changes are made and
10.5.1 To Create a Backup File
Note: The Touchpoint Plus system must be turned off to change the SD card so alternative safety arrangements should
be put in place prior to starting this procedure.
The TPPL has limited capacity to store events in its onboard memory so do not keep the Event logging SD Card
1) Login as Administrator.
2) Touch Menu>Maintenance> Power-off>Yes
3) Switch off and isolate the TPPL power supplies.
4) Open the TPPL enclosure door.
5) Temporarily replace the TPPL SD Card with an empty SD card.
6) Close the enclosure door.
7) Switch power back on and wait for the system to stabilise.
8) Login as an Administrator.
9) Touch
Menu>Configuration>Config Manager>Export
10) Enter a file name for the backed-up configuration and touch [Finish].
11) Touch
Export>Yes
several minutes, and progress is shown on screen.
12) When the backup is completed, touch
13) Switch off and isolate the TPPL power supplies.
14) Open the TPPL enclosure door and replace the backup SD Card with the original or a spare card.
15) Close and secure the enclosure door and return the system to normal operation.
MAN0984_Iss 3_02/16
Pt. No. 3011M5001_3
confirmed to be OK.
out any longer than necessary.
and, if the file name is valid, it will start the configuration backup process. The backup may take
Menu>Maintenance> Power-off>Yes
CAUTION
CAUTION
.
.
111
.
Touchpoint Plus
Technical Handbook