Internal I/O Connectors - Intel D850GB Technical Product Specification

2.8.2 Internal I/O Connectors

The internal I/O connectors are divided into the following functional groups:
•
Audio (see page 54)
 Auxiliary line in
 ATAPI CD-ROM
 Legacy style (2-mm) CD-ROM
 PC/PCI
•
Power and hardware control (see page 56)
 Fans (4)
 ATX12V
 Main power
 Auxiliary power
 Wake on LAN technology
 Wake on ring connector
•
Add-in boards and peripheral interfaces (see page 59)
 CNR (communication and networking riser)
 PCI bus (5)
 AGP
 IDE (2)
 SCSI LED
 Diskette drive
2.8.2.1 Expansion Slots
The board has the following expansion slots:
•
One Accelerated Graphics Port (ATX Expansion slot 6, J5E1), or AGP50 Graphic Port
(optional).
•
Five PCI Local Bus slots (compliant with PCI rev 2.2 specification). The SMBus is routed to
PCI bus connector 2 only (ATX Expansion slot 4, J4B1). PCI add-in cards with SMBus
support can access sensor data and other information residing on the desktop board.
•
One CNR (optional), shared with PCI bus connector 5 (ATX Expansion slot 1, J4A1).
NOTE
This document references back-panel slot numbering with respect to processor location on the
board. The AGP slot is not numbered. PCI slots are identified as PCI slot #x, starting with the
slot closest to the processor. The CNR slot shares PCI slot 5.
The ATX/MicroATX specifications identify expansion slot locations with respect to the far edge of
a full-sized ATX chassis. The ATX specification and the board's silkscreen are opposite and could
cause confusion. The ATX numbering convention is made without respect to slot type (PCI vs.
AGP), but refers to an actual slot location on a chassis. Figure 11 on page 59 illustrates the
board's PCI slot numbering.
Technical Reference
53