Precor C954i Owner's Manual page 20

C O M M E R C
Diagram 18 Attach the power
cord clip.
Cord clip
Front panel
Power cord
Incline lift
CAUTION: To make sure the power cord is not pinched or damaged by the
incline lift, attach the power cord to the base frame using the clips provided.
15. Attach the power cord clip. Diagram 18, #1. Remove a cord clip from the
Hardware kit. Wrap it around the power cord near its receptacle and clamp it shut.
16. Insert the clip into the base frame. Diagram 18, #2. Insert the serrated portion
of the cord clip into the hole located under the front panel on the base frame.
Install the
Diagram 19
remaining
cord clips.
Side rail
Power cord
17. Install the remaining cord clips. Diagram 19. Wrap at least two more cord
clips around the power cord and insert the clips into the holes found in the
frame beneath the side rail. The holes are spaced a foot apart (approximately
31 cm) along the length of the side rail.
18. Plug the power cord into a dedicated, grounded circuit. Place the clips
as needed along the length of the power cord while you route it to the power
outlet.
Important: Check the length of the power cord to make sure that it cannot
get pinched or damaged by the incline lift movement.
CAUTION: The treadmill requires a dedicated, grounded circuit. A 20 amp
dedicated circuit is recommended. Make sure that no other product or
machine uses the same circuit as the treadmill. Refer to Grounding
Instructions .
page 20
I A L P R O D
1
U C T S D I V I S I O N
2