Shindaiwa B530 Owner's Manual page 9

Throttle Cable Adjustment
1. Test throttle control for smooth
operation. If stiffness or binding are
noted, the cause must be identified and
corrected before the brushcutter can be
placed in service.
7mm Free Play
2. Check the throttle control lever "free
play" clearance. "Free play" should be
approximately 7 mm in the idle position.
If necessary, the "free play" clearance
can be adjusted as follows:
a. Slide the adjuster cover forward to
expose the cable adjuster.
b. Loosen the cable lock nut.
c. Thread or unthread the cable adjuster
until the throttle control lever has
approximately 7 mm of "free play"
clearance.
d. Tighten the cable lock nut.
e. Slide the adjuster cover over the cable
adjuster.
Carburetor
Adjuster Cover
Cutting Attachment Shield Assembly
WARNING!
NEVER operate this machine
without the cutting attachment shield.
Operating without the cutting attach-
ment shield may result in serious
injury.
1. Insert the cutting attachment shield
between the outer tube and the lower
clamp.
It may be necessary to loosen the lower
clamp bolt so that the shield will fit
between the tube and clamp.
2. Fit the upper clamp over the outer pipe
and install four bolts finger tight.
3. Tighten the lower clamp bolt and nut
securely.
4.
Securely tighten four upper clamp bolts in
a crisscross fashion.
and cutting attachment shield assembly
to make sure they are tightened securely
and do not wobble.
CAUTION!
Make sure the clamp screw and
retaining nut are securely tightened
before tightening the four socket head
cap screws.
Cable Locknut
Cable Adjuster
B530ES_13
NOTE:
WARNING!
Carefully inspect the gearcase
Sub-Shield
(when trimmer head is in use)
1. Attach the shield extension to the
cutting attachment shield.
WARNING!
NEVER use this machine without
sub-shield when using a trimmer
head.
CAUTION!
Make sure the sub-guard is
completely hooked at the hook
receiver.
CAUTION!
The line cutter is attached to the shield
extension and must be used when
operating with a trimmer head.
WARNING!
The line cutter is very sharp.
When handling, wear gloves to protect
your hands.
9