Shindaiwa B530 Owner's Manual page 11

Installing Trimmer Head
To install a trimmer head
1. Position the brushcutter with the head
of the shaft bolt facing up.
2. Remove the shaft bolt, bolt guard,
Holder B and the retainer clip(s) from
the output shaft.
Gearcase Shaft
IMPORTANT!
The shaft bolt, bolt guard, and retainer
clips are not used with a trimmer head
cutting attachment. Save these parts for
future blade installation.
3. Re-install Holder B on the output shaft.
4. Rotate the holder until the hole in the
holder aligns with the notch on the
gearcase flange. Using the hex wrench,
lock the gearcase as shown.
5. While holding the holder with the hex
wrench, thread the trimmer head onto
the gear-shaft and install securely using
hand pressure. Turn counterclockwise
to install.
6. Remove the hex wrench.
Hex Wrench
The brushcutter can now be used as a
grass trimmer
Installing the Stabilizer
The shaft bolt and bolt guard are not used
with a stabilizer. Save these parts for
future use without a stabilizer.
To install a stabilizer
1. Position the brushcutter with the head of
the shaft bolt facing up.
Holder B
2. Remove the shaft bolt and bolt guard
from the output shaft.
Tighten the Bearing Shaft
Bearing Shaft
Holder A
Holder
3. Lock Holder A with the hex wrench and
thread the bearing shaft on the output
shaft hand tight turning counterclock-
wise. Then, tighten the bearing shaft
with the open end wrench securely.
4. Remove the hex wrench and the open
end wrench.
5. Install the stabilizer to the holder with
the 3 bolts securely.
Tighten the Bolts evenly
Bolts
Stabilizer
IMPORTANT!
Hex Wrench
11