Shindaiwa B530 Owner's Manual page 8

Powerhead Assembly
Install Mainshaft and Outer Tube
CAUTION!
Do not remove the D-shaped shim
washer! The shim washer prevents
damage from overtightening the tube
clamp screw.
1. Place the powerhead on a flat surface,
resting on its stand.
2. Lubricate the mainshaft splines with
molybdenum disulfide (moly) type
grease.
3. Loosen the 6mm socket head cap screw
on the powerhead connector clamp.
Verify that the D-shaped shim washer is
positioned as shown below.
Connector Clamp
Hex
Wrench
B530ES_04
CAUTION!
Do not force the outer tube into the
powerhead! Forcing the outer tube
into the powerhead may damage
the splines on the mainshaft and/or
clutch drum shaft. If installation proves
difficult, rotate the powerhead or
mainshaft until you feel the mainshaft
splines slide into the clutch drum shaft.
4. Insert the shaft tube assembly into the
powerhead connector clamp. Make sure
the powerhead connector clamp aligns
with the outer tube "Insert up to here"
decal.
5. If necessary, rotate the outer tube
assembly until the gearcase output shaft
is pointing down, opposite to the spark
plug.
6. Tighten the union clamp screw securely.
Fan Cover Housing
Mainshaft
Installation Decal
Outer Tube
8
Handlebar Installation
1. Remove the 4mm retaining screws and
lower cap from the handlebar bracket.
2. Mount the handlebar on the outer tube
and align it with the "Attach Handle On
This Line" decal.
3. Reinstall the lower cap and retaining
bolts. Tighten the retaining screws
evenly.
Installation
Decal
Outer Tube
Lower Cap Retaining Screws
Throttle Cable Installation
1. Slide throttle cable and terminal wires
through the cable clamp and grip.
2. Install the throttle cable sleeve on the
Shim Washer
powerhead throttle cable.
Hanger
Cable
Clamp
Powerhead
Throttle Cable
3. Connect the powerhead and the throttle
cable ends.
Make sure the end of the powerhead
throttle cable jacket fits in the grooved end
of the cable connector.
Powerhead
Throttle Cable
Tank Guard
Throttle Assembly
Throttle Cable
Handlebar Bracket
Handlebar
Cap
Grip
Ground
Terminals
Throttle Cable
Stop Switch
Sleeve
Terminals
IMPORTANT!
Throttle
Cable Sleeve
Sleeve
Throttle Cable Installation
(Continued)
(a) Center the throttle cable sleeve over
the connected cable ends and place the
assembly in the throttle cable connector.
(b) Using hand pressure, close the throttle
cable connector.
Throttle Cable
Connector
B530ES_11
(c) Secure each end of the throttle
connector with a cable tie.
4. Connect the powerhead and stop switch
wire terminals.
5. Connect the stop switch ground wire and
the powerhead ground wire terminals.
6. Slide throttle cable and connect terminal
wires into grip by gently pulling on the
throttle cable housing.
Throttle Cable
Housing
Pull
Cable Ties
Throttle Cable
Sleeve
Stop Switch
Connector