Precor C952i Product Owners Manual page 63

Place the right side upright support near the base
frame side bracket. Feed the display cable through the
upright support.
Note: If you encounter difficulties feeding the cable, tie
a string to the cable connector and the other end to a
washer. Feed the washer through the upright support
and pull it and the cable connector out of the base
hole. Remove the string.
Commercial Treadmill Assembly Guide
Pull the cable through the side bracket hole in
the base frame, and then connect the cable to
its receptacle on the lower board near the
motor.
Secure the upright support to the side bracket using two
socket head screws (C), two washers (E), and two barrel
spacers (F). Secure the upright support to the front panel
using two screws removed in step 2 and two washers (B)
from the hardware kit. Finger tighten.
Important: Do not securely tighten the screws until the unit
has been fully assembled. Make sure the fasteners do not
pinch the cable. Cables damaged by improper installation
will not be covered by the Precor Limited Warranty.
Note: Place excess cable inside the upright support.
Secure the display console to the
right upright support using two
buttonhead screws (A) and two
washers (B). Finger tighten.
5